On expansion valve systems THE VALVE MUST BE REMOVED before the evaporator can be flushed. FLUSHED CONDENSERS FROM OUTLET TO INLET AND EVAPORATORS FROM INLET TO OUTLET.
WARNING: NEWER STYLE CONDENSER DESIGNS ARE VERY HARD, AND SOMETIME IT WOULD BE IMPOSSIBLE TO DO FLUSH, IN THOSE CASES IT IS SUGGESTED THAT IF THE COMPRESSOR HAS A MAJOR FAILURE THE CONDENSER SHOULD BE REPLACED. Drain all the oil from the new compressor and dispose of according to local, state and federal laws. NOTE: if you compressor has a drain plug you will need to open it up and drain what oil is in there too. Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated.Install new receiver drier or accumulator and new orifice tube or expansion valve. Evacuate the A/C system for a minimum of one hour. After evacuation install half the refrigerant charge and let the system set for 1 minute. Start engine whit A/C controls on MAX AIR with door and windows open. Add the remaining charge of refrigerant as called for by the manufacture. This deposit would be reimbursed once the original compressor is received back. Please, Have your system checked by a professional to guarantee a long and sustainable ac system for years to come. Thank you and here always to help. YOUR SATISFACTION IS OUR MAIN GOAL.