A/C Compressor Kit Fits BMW 545i 550i 645Ci 650i OEM 7SEU17C 97358

You are purchasing a Reman compressor with clutch. Follow all local, state and federal regulations when servicing mobile A/C systems and read this instruction sheet prior to starting any repairs. Oil charges and oil types should be closely adhered to for proper A/C performance.

If you are uncertain of OIL CHARGE OR REFRIGERANT TOTAL SYSTEM CHARGE refer to the under hood decal or, OEM service manual. USE ONLY R-12 OR R-134a REFRIGERANT. Remove compressor, receiver drier or accumulator, orifice tube or expansion valve.

Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems THE VALVE MUST BE REMOVED before the evaporator can be flushed. FLUSHED CONDENSERS FROM OUTLET TO INLET AND EVAPORATORS FROM INLET TO OUTLET. WARNING: NEWER STYLE CONDENSER DESIGNS ARE VERY HARD, AND SOMETIME IT WOULD BE IMPOSSIBLE TO DO FLUSH, IN THOSE CASES IT IS SUGGESTED THAT IF THE COMPRESSOR HAS A MAJOR FAILURE THE CONDENSER SHOULD BE REPLACED.

Drain all the oil from the new compressor and dispose of according to local, state and federal laws. NOTE: if you compressor has a drain plug you will need to open it up and drain what oil is in there too. Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated. Install new receiver drier or accumulator and new orifice tube or expansion valve.

Evacuate the A/C system for a minimum of one hour. After evacuation install half the refrigerant charge and let the system set for 1 minute.

Start engine whit A/C controls on MAX AIR with door and windows open. Add the remaining charge of refrigerant as called for by the manufacture. YOUR SATISFACTION IS OUR MAIN GOAL.

---